this is right setting for CB?

612134

{"replyTo":"","text":"its still not working? did you take any or all of the advice that was given to you?","replyToPid":0}

972023

{"replyTo":"

612134 发表于 2020-06-14 17:59:28 its still not working? did you take any or all of the advice that was given to you?

","text":"I paid $150 with installation, it worked when he installed.\nI'm thinking I messed up something","replyToPid":384232}

612134

{"replyTo":"","text":"But, first. is that you in your picture? 🧐","replyToPid":0}

612134

{"replyToPid":384238,"replyTo":"

972023 发表于 2020-06-14 18:20:45 This comment has been deleted

","text":"sorry to hear that driver"}

687163

{"replyTo":"

612134 发表于 2020-06-14 18:23:06 sorry to hear that driver

","text":"maybe u knocked off the antenna. also calibrate ur mic. it will show u on YouTube. its ez.","replyToPid":384240}

674413

{"replyTo":"","text":"Swr way to high rf way to high dynamic way to high volume to low can’t see the sql but if it’s down all the way you should hear static ","replyToPid":0}

627125

{"replyTo":"","text":"first thing I seen wrong is your calibration knob is turned all the way to the right. you need to calibrate the radio to the antenna . turn the switch to SWR leaving on channel 19 and get the lowest SWR impossible by turning the calibration knob to the left until you get the lowest possible SWR then your radio is also tuned with the antenna . then leave it there. if you cannot get it under 2.0 you need to lower the antenna stem or shorten it.","replyToPid":0}

627125

{"replyTo":"","text":"anyone that tries to install a radio and antenna without going online that doesn't know anything about tuning should not even be a truck driver","replyToPid":0}

627125

{"replyTo":"","text":"drivers look at the volume and then look at the squelch, if the squelch is turned all the way to the right the RF gauge would be sitting around center, not at zero that radio is dead","replyToPid":0}

627125

{"replyTo":"","text":"don't believe me try it on your own radio","replyToPid":0}