Does anyone else twist their straps on certain loads like this?🤔I was told its better than throwing them straight across

829688

{"replyTo":"","text":"a half if a twist keeps the straps from vibrating without overtightening. it's a great practice on material that is soft.","replyToPid":0}

311976

{"replyTo":"","text":"I only did it on tall fragile loads, styrofoam, PVC ect. If it's anything else, you can get flat straps on ridged loads much tighter so long as you tighten them down good, they won't flap.","replyToPid":0}

787563

{"replyTo":"","text":"Yes absolutely.No flapping in the wind.","replyToPid":0}

661607

{"replyTo":"","text":"Yes, they don't flutter inna wind and most of the time they stay tight.","replyToPid":0}

646676

{"replyTo":"","text":"definitely","replyToPid":0}

788398

{"replyTo":"","text":"I have  told they help better  to hold the load and go nicely with win as well so it’s all good I like it ","replyToPid":0}

824414

{"replyToPid":0,"replyTo":"","text":"prevents flapping like the person above me said.. a half twist is ok.. a full twist will get you pulled in for a lvl 1.. except steel on steel do not twist.. cables or chains.. unless you have a block system set up.. to increase capacity.."}